![]() Heavy load towing and fuel economy tunes included.Internet updateable with all-new update software via USB.Automatic transmission shift optimization.Tuning works with aftermarket hard parts.Calibrate for tire sizes from 22.5" to 42" (JK Only).Adjust idle in real time to run accessories.Eliminate downshifting when climbing hills.Power, fuel economy & towing tunes (Up to 20% improvement in power).Increased memory with faster processor for improved tuning and updating speed.Redesigned graphic interface for improved user experience.If throttle response is good and vehicle stays running, please continue by shutting off engine, returning ignition to ON, and pressing OK on F5. The vehicle shutting off after ~3 seconds, or having a dead pedal indicates that there was an issue reading stock data and/or writing stock data to Unlocked PCM. ![]() Let the Vehicle Run for more than 3 seconds, and test throttle response. **Before pressing OK on your F5, Start the Vehicle. **At this point, the cluster panel should no longer have the red security light illuminated which signals that your JL has been programmed, and connected to, the Unlocked PCM. This is expected and part of the process. *On first power up with an Unlocked PCM the cluster panel will illuminate the red security light and may warn about other module errors (Traction Control, ABS, etc.). You will need to follow device screen prompts from this point forward. Vi.Progress, % read complete, Reading File 1 of 2Ħ.Tuner will read PCM and continue tuning your vehicle. Iv.Ignition On Prompt Screen** (Ignition ON = double tap on push start) I.Transferring Factory Data to Unlocked ECU. Connect Battery.ĥ.With Unlocked PCM installed, connect Tuner to Vehicle.* Disconnect Battery.Ĥ.Remove Factory PCM (10mm) and Install Unlocked PCM. Steps 3 5: Installing Unlocked PCM and Installing a Tune with the Flashpaqģ.Turn Ignition Off. These steps below should be followed only after receiving your unlocked PCM from Superchips. Navigate to the update tab and then proceed to download Update Agent 1.0 software and connect your Flashpaq. Next, you will need to proceed to to submit your vehicle information and request and unlocked PCM. *This is normal and pressing OK continue will allow the device to continue reading your stock file.Īfter completing steps 1 & 2, you will need to proceed to update your device. *Please note, upon connecting your Flashpaq, you may be presented with an alternate screen that indicates the following: Iii.Successfully Retrieved Data from Factory ECU! Proceed With Installing Unlocked ECU With Factory PCM still installed, connect Tuner to Vehicle. Security Bypass Install & PCM Swap Processġ.Install the provided Security Bypass Module. ** This product has not been tested or validated on right-hand drive Jeep applications or imported (non-American VIN based) Jeep applications. ![]() Please note you will still need to install your bypass module and connect to your vehicle prior to swapping PCM. ![]() Once we receive your stock PCM, we will quickly unlock it and get it back to you so you can tune with your Flashpaq. Please contact technical support to begin. This free service will be available to you anytime. Option 2: Send in your factory PCM to be unlocked This process is all online and very simple. You must connect to your vehicle and follow the instructions prior to proceeding with the PCM swap., Upon confirming the first steps, take your VIN and your product and head to to Once you proceed, you will need to set up a PCM shipment and the included pre-authorization to secure that shipment. Option 1: Cross-ship PCM swap (subject to availability of PCMs)Īfter you receive your 3876-JL Flashpaq be sure to follow the bypass module instructions included with your device. ***This product requires a PCM swap in order to tune your Jeep*** It is important that you follow the important steps required to tune this exciting vehicle. Please review all product details and features below. Superchips will continue to offer a best-in-class PCM swap process for the 2018-2019 JL Wrangler. Enjoy an extensive set of custom features accompanied with power gains of up to 29 HP & 37 lb-ft TQ. The Flashpaq for 2018-2019 3.6 JL Wrangler is here and demand has been off the charts. SAVES FACTORY SETTING AND RETURNS EASILY TO STOCK ![]()
0 Comments
Leave a Reply. |